We came up with three blueprinted designs for our stabilization device of the grabber.

Our first design was a single piece. It was named the “Corner Hanger” as it would be attached to the corner of the whiteboard, and the grabber would be stabilized on two hooks, put through the claw of the grabber. As it would be hard to stabilize our corner hanger on the corner itself, we moved onto Test Subject 7000B. We decided after critical minutes of thought and research that the problem was the corner. As such, “ Grabber DuoHanger V1.2 ” was born. We kept the blueprint of the Corner Hanger, and use the two hooks to hang the grabber on the front side of the whiteboard. This way, it could be much more stabilized then the Corner Hanger. Then we had our legendary, ingenious idea. Going with a similar design to the duohanger, we decided to hang the grabber vertically, and then use two parts to the device over a single piece to add two points of stability. This ingenious design is truly worthy of the name “Grabber Stabilization Device”.